Download Event Setups to the OmniSport 6000 Timing Console

Previous  Top  Next

Overview
This feature provides the ability to download your currently selected MM "Run the Meet" event list to the OmniSport 6000 timing console. This feature is included when you purchase The INTERFACE option and is a great time saver which will be appreciated by your OmniSport 6000 timer operator. All events for the current session will have event numbers and event titles available. So, instead of having to key in meet and event setups into the OmniSport 6000, like Event 1 BOYS 100 FREE 11-12 FINALS, the INTERFACE provides the information directly with NO data entry and NO mistakes!

The OmniSport 6000 timer will accept your new setups ONLY if you prepare it as follows:

1.

Press Edit on the OmniSport 6000 Main screen.

2.

Press Event Order.

3.

Select one of the User Defined Event Order slots.

4.

Press Download and confirm with Yes.

5.

From the Run Menu in HY-TEK, select Timer / Download Events to DAK6

Please Note

You must already have the serial port open and communicating with the OmniSport 6000 and you are limited to downloading only events numbered 1 through 150.

The INTERFACE will transfer event set-ups ONLY if:

1.

Your MM is in the Run module selected by clicking Run from the Main Menu bar.

2.

The current session (or All Events) selected does not have the same event listed twice and none of the events have alpha-numeric event numbers.

Downloading Event Setups
First ready the OmniSport 6000 by selecting Edit and then Event Order. Now select User Defined 1 or User Defined 2 by using the down arrow key and then press Select to place an "X" next to your choice. Press Download and then select "Y" to place the OmniSport 6000 in ready to download status.

In MM, click on Interfaces then Timer from the Run Screen Menu Bar and then click Download Events to DAK6. MM will prompt you to click Yes to begin download of events displayed at the top left of the "Run the Meet" screen. The download will only take a few seconds. If the serial port in MM has not been opened, then refer to the next section.